// blog
Known-Good Readings for 75 Boards, Looked Up by Board Number
Look up a board by its number, such as 820-00165, and you get every power rail sorted by startup stage with its known-good diode, voltage and resistance readings, every other net with a reading, and the board’s repair notes. There are pages for 75 boards, mostly Apple laptops, from the OpenBoardData archive. No file to open, nothing to install.

Sometimes you just want the number. The board is on the bench, the meter is in your hand, and you want to know what PP3V3_S5 should read on this board, without opening anything.
So every board in our snapshot of OpenBoardData with at least ten readings now has its own page: 75 boards, 53 Apple laptops, 17 Apple phone boards, four desktops and one console. Find yours by its number.
What’s on a board’s page
Take the 820-00165:
- Power rails by startup stage. All 104 rails with readings, grouped the way the board brings them up: G3H always on, S5 and SUS standby, S4, S3 memory, and S0 running. Each with its known-good diode, voltage and resistance values, and the conditions they were taken under.
- Repair notes. Where the archive has them, as on this board’s backlight and power sequence. Rail names in the notes jump to their readings.
- Every net with a reading. All 1,259 of them on this board, with a search box. Type
PP3V3and you get the 3.3 V rails.
The rails come first because tracing power is where most of the time goes on a dead board. Apple writes the power state into each rail’s name, so the page can sort them for you, and the schematic still has the final word.
When you have the board file
The page is the quick look. With the boardview file open in the free Board Viewer, the same readings appear on the pins as you hover, the Power AI tab draws the rails on the board stage by stage, and you can ask AI about any part or net. Name the file with the board number, as in 820-00165.brd, and the readings load by themselves. The file stays on your computer.
Board not on the list?
Open its file in the viewer. If the board number is in the file’s name and the board has no page yet, the viewer asks whether to add it. Your file is never uploaded. If you say yes, only two things are sent: the board number and the names of its power rails, such as PP3V3_S5. Not the file, its parts, its layout or its name. The board gets its own page with every rail sorted by startup stage and an AI note on what each rail is and how to check it, for the next tech with the same board. It has no known-good readings until someone measures a working one and shares them on OpenBoardData.
About the numbers
These are community readings: repair people measured working boards and shared the values. They vary with a board’s state, the meter and which way round the probes went, so treat them as a guide and compare like with like. A board with fewer than ten readings in the archive doesn’t get a page yet. To add or correct a reading, use OpenBoardData’s own site. The data is theirs, under the Open Database License, and our pages show a dated snapshot.
































































































































