// blog
Match the Screen to the Board on Your Bench: Flip, Turn and Measure
To match a boardview to the board in front of you, turn the view with the rotate keys and flip it the way you’d turn the board over. A good viewer never shows a mirror image, because no real board looks like that. In a free browser board viewer, Space flips between sides, B shows both, M and V flip, the angle keys rotate, and D measures the distance between two points or pins in millimetres and mils.

When you probe a board, you look from the screen to the board and back, dozens of times. Every glance is faster when the screen shows the board exactly the way it lies on your bench. Our free board viewer is built around that.
Never a mirror image
You can turn a board, and you can turn it over. You can’t mirror it. So the viewer never shows a mirror image either, whichever button you press. The bottom side is drawn as you see it when you turn the board over, as in OpenBoardView.
That matters more than it sounds. A mirrored view puts a chip’s pin 1 in the wrong corner, and on a dense board that’s how probes land on the wrong pad.
One side or both
- Space turns the board over, from the top to the bottom and back.
- B shows both sides at once, one above the other.
- Top and Bottom in the toolbar show one side.
Flips
With one side showing, both flips turn the board over: M (Flip H) across, V (Flip V) top to bottom, just as you’d turn it in your hands.
With both sides showing, the flips match other boardview tools: M gives the whole view a half turn, and V swaps the two sides, each keeping its own way up.
Turn it
< and > (or R) turn the board a quarter at a time, so the connector on the screen points where it points on your desk. F fits the whole board back on screen, and + and - zoom.
Measure
Press D, or Measure in the toolbar, then click two points or two pins. You get the distance in millimetres and in mils. That’s handy for checking a part’s footprint against a replacement, or how far a pad sits from the board’s edge. Esc clears the measurement and the selection.
Find it fast
Ctrl+F finds a part or a net. Pick one and the view turns the board over if that’s the side it’s on. With the schematic open, the PDF goes to it too.
On a phone
At the bench, a phone propped up next to the board works. The toolbar becomes one row you swipe, and View opens as a panel at the bottom of the screen. Pinch to zoom and drag to move.
The viewer remembers your view settings in your own browser. Your board file stays on your computer, and it’s gone when you close the tab.
































































































































